DigiTech JamMan SOLO XT Owner's Manual download pdf (Page 45)

Playing Back Loops Using JamSync

To initiate playback on synced JamSync devices:

1. Press the <PEDAL SWITCH> on any

slave device which you want to arm

for playback. The STATUS LED will

ﬂash green, indicating the slave device

is armed for sync playback.

2. Press the <PEDAL SWITCH> on the

master device to initiate playback. The

master device will begin playing back

along with any slaved devices which

were armed for playback in step 1.

3. To then cue slaved devices for

playback, press the slave device’s

<PEDAL SWITCH> at any time

during master loop playback. The

STATUS LED will ﬂash green,

indicating the slave device is cued for

sync playback. The slave device will

begin playing back the next time the

master device’s loop start point is

reached.

4. To stop loop playback of a slave

device, quickly press the <PEDAL

SWITCH>

twice.

5. To stop loop playback of all devices,

quickly press the master’s <PEDAL

SWITCH>

twice.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 71 72

No comments

DigiTech JamMan SOLO XT Owner's Manual Page 45