DigiTech JamMan SOLO XT Owner's Manual download pdf (Page 30)

To Undo/Redo/Clear a recorded overdub:

1. Select an existing loop in memory

using the <UP/DOWN> buttons or

load an empty memory location and

record and store a new loop.

2. Record your overdub as described in

“Operation > Recording Overdubs”. When

done, press the <PEDAL SWITCH>

to initiate loop playback (the STATUS

LED will light green).

3. To Undo an overdub, press and hold

the <PEDAL SWITCH> while the

loop is playing until the STATUS LED

begins to quickly ﬂash yellow and you

see und in the LED display. The Undo

function is now complete.

4. If you wish to restore (Redo) an

overdub, ensure the loop is still playing

and press and hold the <PEDAL

SWITCH>

again until the STATUS

LED begins to quickly ﬂash yellow and

you see rEd in the LED display. The

Redo function is now complete.

5. Repeat steps 3 and 4 to compare the

original loop with the loop containing

the newly recorded overdub.

6. To clear the overdub, stop loop

playback by quickly pressing the

<PEDAL SWITCH> twice and

continue to hold the <PEDAL

SWITCH>

until the STATUS LED

begins to quickly ﬂash yellow and you

see CLr in the LED display. The Clear

function is now complete.

NOTE: The Clear function cannot be undone! Clearing can also be done using an FS3X footswitch

(see “Optional FS3X Footswitch”). Clear, Undo, and Redo functions are no longer available once the

loop or overdubs have been stored to memory.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 71 72

No comments

DigiTech JamMan SOLO XT Owner's Manual Page 30