DigiTech JamMan SOLO XT Owner's Manual download pdf (Page 24)

Recording a Loop Using Pedal Tempo (Auto Quantize)

See “Setup > Pedal Tempo” for information on enabling the Pedal Tempo feature.

1. Select an empty memory location

using the <UP/DOWN> buttons

(LOOP and SINGLE LEDs will be off).

2. Set the <RHYTHM LEVEL> control

to the 9 o’clock position.

3. Press the <PEDAL SWITCH> a few

times at the rate you want the phrase

tempo to be. You will begin to hear

the Rhythm Guide Track and the beats

will be indicated by a ﬂashing TEMPO

button LED. Repeat this step to ﬁne

tune the tempo, if necessary. When

using the Rhythm Guide Track, time

signature can be manually set to a

different time signature other than the

default of 4 beats per measure (see

“Setup > Time Signature”).

4. To exit Pedal Tempo Mode and

prepare for recording, press and

hold the <PEDAL SWITCH> until

the TEMPO button LED repeatedly

ﬂashes yellow, then release.

5. Press the <PEDAL SWITCH> to

initiate recording. You will receive

a one bar count in, indicated by a

ﬂashing red and green STATUS LED.

After the count in, begin playing with

the ﬁrst beat to start recording.

Recording will be indicated by a solid

red STATUS LED.

6. As soon as you’re done recording,

press the <PEDAL SWITCH> again to

stop recording and initiate playback.

7. Quickly press the <PEDAL SWITCH>

twice to stop loop playback.

8. Press the <STORE> button twice if

you wish to store the loop.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 71 72

No comments

DigiTech JamMan SOLO XT Owner's Manual Page 24