DigiTech RP500 Owner's Manual download pdf (Page 24)

VibroPan (vibropan)

A vibrato is an effect that modulates the pitch of the incoming signal. This will take the whole

signal slightly in and out of tune at a steady pace. The DigiTech

VibroPan also incorporates an

automatic panner with the vibrato effect that creates a lush chorus-like sound.

Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn

counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post

(appears after the Noise Gate effect).

Speed - Knob 3 adjusts how fast the signal is being modulated.

Depth - Knob 4 adjusts the amount of pitch change.

Vibrato/Pan- Knob 5 adjusts the amount of panning incorporated with the vibrato effect.

When set at 0, this effect is a standard vibrato. As the parameter is turned up, the phase

difference of the vibrato signal sent to the two channels is changed until a full stereo image

is obtained at 99.

Waveform - Knob 6 selects a waveform: triangle, Sine, or Square.

Unicord Uni-Vibe

(unovibe)

Based on the Unicord

Uni-Vibe

pedal, Uni-Vibe adds a lush chorus or rotary speaker (vi-

brato) effect to your tone.

Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn

counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post

(appears after the Noise Gate effect).

Speed - Knob 3 adjusts the rate (Speed) of the chorus modulation or spinning speaker

(vibrato) effect. Ranges from 0 to 99.

Intensity - Knob 4 controls the intensity of the effect. Ranges from 0 to 99.

Chorus/Vibrato - Knob 5 selects either the chorus or vibrato effect. Turn counter-

clockwise for Chorus, or clockwise for Vibrato.

Volume - Knob 6 adjusts the volume of the effect.

Tremolo/Panner

A Tremolo effect modulates the volume of the signal at an even rate. The RP500 includes the

following Tremolo types: tremolo (the DigiTech

Tremolo), sctrtrem (DigiTech Scattertrem

(dual asynchronized tremolos)), optotrem (based on the Fender

Opto Tremolo), biastrem

(based on the Vox

Bias Tremolo), and panner (the DigiTech Panner).

Pre/Post Amp - Knob 2 determines where the effect appears in the effects chain. Turn

counter-clockwise for Pre (appears before the Distortion effect), or clockwise for Post

(appears after the Noise Gate effect).

Speed - Knob 3 adjusts the rate (Speed) at which the volume modulates. Ranges from 0

to 99

Depth - Knob 4 adjusts the intensity (Depth) of the modulating volume. Ranges from 0

to 99.

Waveform (DigiTech Tremolo and Panner only) - Knob 5 selects a waveform:

triangle, Sine, or Square.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 35 36

Comments to this Manuals

No comments

DigiTech RP500 Owner's Manual Page 24

Comments to this Manuals

Related products and manuals for Music Pedal DigiTech RP500