DigiTech RP350 Installation Guide

Software Installation GuideInstalls Cubase® LE 4, X-Edit, and USB Drivers

82. Make sure the Show Inspector button , located in the upper left corner of the screen is lit. 3. In the Audio 01 window, make sure the Record E

94. In the Audio 01 window, make sure the Input Monitoring button is not lit. C. To sTarT reCorDing 1. Click the Record button on Cubase® LE 4’s

8760 South Sandy ParkwaySandy, UT 84070Tel: (801) 566-8800Fax: (801) 566-7005http://www.digitech.comCubase and ASIO are trademarks of Steinberg Media

Table of ConTenTs1. Congratulations ...

11. CongraTulaTionsCongratulations on your purchase of the RP350™. This guide contains the instructions on installing and setting up Steinberg Cubase®

2Click the “RP350 Drivers” button and follow the onscreen instructions to install the necessary drivers for using X-Edit and Cubase. Click the “X-Edit

3C. Cubase® le 4 DeViCe seTup for WinDoWs®After the RP350TM is connected to your computer and powered on, open Cubase LE 4, and go to Devices>Devi

44. sofTWare insTallaTion for maC® usersThe RP350TM hardware is designed to interface directly with your Mac® computer via USB using OS X’s Core Audio

5Click VST Audio System and select DigiTech RP350 In/Out (2) as the ASIO Driver (as shown below). DO NOT select DigiTech RP350 In/Out (1).Cubase® LE 4

6reCorDing WiTH Cubase® le 4 (WinDoWs® anD maC®)a. CreaTing a neW projeCT1. Open Cubase® LE 4. 2. Click File and select New Project.3. Select defau

74. Select a location to store the project (or use the default location) and click OK. You may want to create a new folder for each new project. 5.