DigiTech HARDWIRE HT-6 Owner's Manual download pdf (Page 27)

Setting The Fret Offset Manually

1. Hold down the Foot Switch until the LED Matrix Display shows

“FRET” and the Note Display shows the current offset (usually 0 if

being set for the first time).

2. While holding down the Foot Switch, press the Tuning Button or

Mode Button to set the fret offset (-1 to -6 for drop tune, 0 for no

offset, or 1 to 6 for capo).

3. Once the offset you want is selected, release the Foot Switch. The

“Ready to Tune” state is re-entered after no button presses for 3

seconds.

NOTE: Setting the Fret Offset does not change the tuning reference. Therefore, when tuning while

using a Fret Offset, the true pitch of the note being played will be displayed. This means if A440

is the selected tuning reference and you set the Fret offset to +1 and then play the low E string

(without a capo), E will be the displayed note, which is the actual true pitch of the note.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

No comments

DigiTech HARDWIRE HT-6 Owner's Manual Page 27