DigiTech Whammy DT Owner's Manual

Owner’s Manual

Page 6Harmony EffectsThis group of effects add a harmony to your incoming signal. Both the harmony note and the input signal are mixed together as if

Page 7Detune EffectsThis group of effects creates a copy of your input signal, shifts the pitch of the copied signal and mixes it back with the origin

Page 8Drop Tune EffectsThis group of effects allow you to transpose (shift) your instrument up or down – with a range of one octave in each direction

Page 9 Drop Tune Footswitches There are two footswitches below the Drop Tune effect section. The DROP TUNE footswitch is used to turn the Drop Tune ef

Page 10 MIDI Functions The Whammy DT features a MIDI input for receiving incoming MIDI data. MIDI messages can select a Whammy or Drop Tune effect and

Page 11 MIDI Program Changes The Whammy DT uses MIDI Program Change commands for effect selection. Effects can be selected in either an active or bypa

Page 12Drop Tune Effects MIDI Program Change MappingThe following list outlines the program change commands recognized by the Whammy DT and the corres

Page 13 MIDI Continuous Control Using MIDI continuous control commands the Whammy’s expression pedal position can be remotely controlled. MIDI CC11 ad

Page 14 Bypass Modes There are two selectable Bypass Modes available in the Whammy DT, they are:•True Bypass •DSP Bypass True Bypass ModeFrom the fa

Page 15DSP Bypass ModeThe benefit of using DSP bypass is so the Drop Tune Momentary footswitch can smoothly transition between momentary on and off st

These symbols are internationally accepted symbols that warn of potential hazards with electrical products. The lightning flash means that there are d

Page 16 Calibrating the Expression Pedal In the unlikely event that the expression pedal does not respond properly or that the note does not bend or r

Page 17 FS3X Functions The optional FS3X Footswitch gives you hands-free control over selecting which Whammy and Drop Tune effects are selected.1. Mo

Page 18

Page 19 Specifications Instrument Input Type: 1/4” Unbalanced TSMax Input Level: +5 dBuInput Impedance: 1 MΩMIDI Input: 5-Pin DinFootswitch Input

DigiTech8760 S. Sandy ParkwaySandy, Utah 84070PH (801) 566-8800FAX (801) 566-7005DigiTech and Whammy are trademarks of HarmanCopyright Harman – All Ri

DECLARATION OF CONFORMITYManufacturer’s Name: DigiTech Manufacturer’s Address: 8760 S. Sandy Parkway Sandy, Utah 84070, USAdeclares that the produc

WarrantyWe at DigiTech® are very proud of our products and back-up each one we sell with the following warranty:1. Please register online at www.digi

Page 1Congratulations on the purchase of your new Whammy™ DT Pedal. When DigiTech invented the Whammy pedal, it was the most revolutionary and innova

Page 2 Guided Tour Detailed Description1. WHAMMY Effect Switch This switch turns the Whammy, Harmony or Detune effect on and off.2. Whammy Effect St

Page 35. Expression Pedal This pedal is used to control the pitch bending amount of the selected Harmony, Whammy, or Detune effect. Rocking it forwar

Page 4 Making Connections The Whammy DT pedal is extremely easy to set up and use. Follow these steps to get up and running.1. Connect your instrumen

Page 5 Effects The Whammy DT is a powerful pitch shifting pedal that offers both Drop and Raised re-tuning of your instrument and classic Whammy pitch