DigiTech RP355 Owner's Manual download pdf (Page 13)

Rear Panel

1. Input

Connect your instrument to this high-impedance TS input.

2. Amp / Mixer (for the 1/4" Outputs)

This button optimizes the RP355’s 1/4" outputs for use when plugged into a guitar amp or a

mixer/recording device. When set to Mixer (“In” position; display reads 1/4MIX), speaker com-

pensation is turned on and the outputs are optimized for connecting to a mixer or recording

device. When set to Amp (“Out” position; display reads 1/4AMP), the outputs are optimized for

running directly in to the input of a guitar amp.

3. 1/4" Left (Mono) and Right Outputs

Connect the Left (Mono) output to the input of a single amplifier (or mixer input) for mono

operation. Connect the Left and Right outputs to the inputs of 2 amplifiers (or 2 mixer chan-

nels) for stereo operation.

4. Headphones

Connect stereo headphones to this 1/8" jack. For proper frequency response, the XLR Amp/

Mixer switch should be set to Mixer (“In” position) when using headphones. Headphones with

16-100 Ohm impedance are recommended.

5. Aux In

Connect the headphone output of an MP3 or CD player using a stereo 1/8" cable to this 1/8"

stereo TRS jack for rehearsing with your favorite pre-recorded material, and using the Learn-A-

Lick

feature (see page 27 for more info). Adjust the output level of your playback device and

the RP355’s Master Level knob for the proper volume balance.

6. Amp / Mixer (for the XLR Outputs)

This button optimizes the RP355’s XLR outputs for use when plugged into a power amp/speaker

system or a mixer/recording device. When set to Mixer (“In” position; display reads xlrMIX),

speaker compensation is turned on and the outputs are optimized for connecting to a mixer,

recording device or headphones. When set to Amp (“Out” position; display reads xlrAMP), the

outputs are optimized for running directly in to the input of a guitar amp or power amp.

7. XLR Balanced Line Outputs

Connect these outputs to your power amplifier/speaker system or to a mixing console that

accepts balanced XLR connections. Speaker compensation can be enabled on these outputs

when connected to a full-range speaker system. The XLR outputs are always configured for ste-

reo operation.

8. USB Port

The USB port is for connecting the RP355 to a computer and serves two purposes: (1) for

use with the downloadable X-Edit™ Editor/Librarian software, and (2) for streaming audio to

and from the computer. The RP355 will stream 2 channels up and 2 channels down from the

computer at 44.1kHz, 16 and 24 bit. A utility panel in the Editor/Librarian controls the direct/

playback mix and USB record level with the included Cubase

LE 4 sofware, or any recording

software the RP355 is connected to. Knobs 4 and 5 also control the direct/playback mix and

USB record level when USB is connected and the Pickup Row is selected.

Note: X-Edit Editor/Librarian software and USB drivers can be downloaded at

www.digitech.com.

9. Power Input

Connect only the DigiTech

PS0913B power supply to this jack.

1 2 3 4 5 6 7

8 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 39 40

Comments to this Manuals

No comments

DigiTech RP355 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Processors DigiTech RP355